- 3-phase In/1-phase Out
- True Online Double Conversion Design
- Pure Sine Wave Output
- Fully Digitized Microprocessor Control
- DSP Technology
- Output Power Factor 1
- Active Input Power Factor Correction (PFC 0.99)
- 50/60 Hz Frequency Converter
- Wide Input Voltage Range
- Built in Automatic Bypass
- Generator Compatible
- N+X Parallel Redundancy Configuration*
- Emergency Power Off Function (EPO)
- Cold Start Function (DC Power On)
- Advanced Battery Management (ABM Technology)
- Automatic Diagnostics & Battery Check
- High Overload Capability and Enhanced Short Circuit Protection
- Eco Mode For Energy Saving
- Isolation Transformer*
- Programmable Power Management Outlets
- Multi-Function LCD Display
- Software Monitoring and Control
- Smart RS-232/USB Communication Port
- SNMP/AS-400 Communication Slots*
* Optional Features
DOCUMENTS & DOWNLOADS
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
*When using internal batteries from 18-19, the unit will de-rate according to below formula: P=Prating x N/20 NOTE 1: Derate to 60% of capacity in CVCF mode and to 90% when the output voltage is adjusted to 208VAC. NOTE 2: If the UPS is installed or used in a place where the altitude is above than the rated altitude, the output power must be derated one percent per 100m. ** For optional features ***Product specifications are subject to change without further notice |
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
*When using internal batteries from 18-19, the unit will de-rate according to below formula: P=Prating x N/20 NOTE 1: Derate to 60% of capacity in CVCF mode and to 90% when the output voltage is adjusted to 208VAC. NOTE 2: If the UPS is installed or used in a place where the altitude is above than the rated altitude, the output power must be derated one percent per 100m. ** For optional features ***Product specifications are subject to change without further notice |
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
| ||||||||||||||||||||
*When using internal batteries from 18-19, the unit will de-rate according to below formula: P=Prating x N/20 NOTE 1: Derate to 60% of capacity in CVCF mode and to 90% when the output voltage is adjusted to 208VAC. NOTE 2: If the UPS is installed or used in a place where the altitude is above than the rated altitude, the output power must be derated one percent per 100m. ** For optional features ***Product specifications are subject to change without further notice |